Toyota Tundra Front Winch Bumper Installation Instructions

download
Installation Instructions Toyota Tundra Front Winch Bumper Product Number: H1850, H1851, H1852 Application: ’07-Current Toyota Tundra Copyright sing a deep 14mm socket and breaker bar, loosen the 4 14mm nuts located at the connection between the factory frame end and the bumper. See Image Below. G. Remove the bumper by pulling forward away from the vehicle and rolling forward. H. Remove the two (per side) plastic clips from the painted plastic trim pieces located below the headlights. The Hood must be open for this. See Image Below. I. Remove these plastic painted trim pieces by pulling directly away from the front of the truck. Do not discard these! J. Remove all pop rivets (8 Total) from the front painted plastic bumper upper fascia. See Image Below. K. Remove all bolts holding the painted plastic fascia piece using a 10mm socket and wrench (16 total). See Image Below in addition to Image Above. L. Remove the Phillips pop rivet holding the fascia to the inner fender. 1 per side. M. Remove the two(one per side) 10mm screws from the recessed hole in the inner fender well. N. Pull the edges of the plastic fascia from the truck and directly away from the front to snap free. Set fascia aside. O. Remove the two 10mm screws using a socket from the plastic spacer pieces located on the lower fender. With Screws removed pull bracket straight off the truck. Complete on opposite side. See Image Below Pre-Installation Assembly A. Remove the Bumper from the shipping carton. Lay all items out on a blanket to prevent damage to the powder coating. B. OPTIONAL: If installing winch and roller fairlead (neither provided) into bumper, do it at this time. Follow the winch Manufacturers instructions to mount the fairlead to the front of the bumper and the winch itself to the 4 hole pattern on the internal winch tray of the bumper. C. Install turn signal into light pockets as shown using self- tapping screws as shown below.